As long as you set aside enough time you will be able to install the invisible pattern cut shapes cleanly and correctly. The following guide is a brief instruction to give you an outline of what is required. We will send you more details with the kit.
The key is preparation.
Before you start, try and keep the area as clean as possible. Set up an area where you will not be disturbed and have everything laid out ready.
Identify the cut shapes with the bike and clean the paintwork.
Spray the paint surface as well as the adhesive side of the film with a soapy solution and position on the section where the part is to be installed.
Using the same solution on the top surface of the film, squeegee one section of the cut part out a number of times until it fixes itself to the bodywork.
Spray more water under the rest of the film (you can never use to much water) and pull the film into position whilst pressing out from the fixed point to the end.
It is useful to remember that the film is designed to be stretched. You are using a two dimensional cut shape on a three dimensional profile so be positive and it will form itself over the body lines and contours.
COSTS
We will supply you with the cut shapes, a cutting and identification plan, an installation instruction sheet and a simple black squeegee (as per picture above) for £70.00 total, inclusive of vat and postage. This cost applies to all bikes and subject to shipping within the UK.
We can supply additional material and tools if required (the truth is you will not need any specialised tools apart from the squeegee supplied). Please contact us here if you need any further information and costs.